BULLET STYLE 1157 WHITE-TO-AMBER SWITCHBACK LED LIGHT BULB FOR HARLEY.
These are ULTRA BRIGHT - Bullet-Style turn signal replacement bulbs for Harley-Davidson. PathFinderLED direct replacement bulb replaces your OEM incandescent stock bulbs that come on your bullet style lights on your bike. These are built tough and the solid state design has no moving parts. No extra wires dangling inside the bike's housing or possibility of loose boards these are designed to withstand the tough roads and everyday abuse. Plug N Play installation make these bulbs a snap.
NOTE: Based on our experience and user feedback, our LED bulbs lights up micro seconds faster which helps with increasing driver reaction time which makes a huge difference when a car is trailing the rider from behind.
- Ultra bright switchback design White-to-Amber
- Solid state rugged design - built to withstand everyday riding
- No moving parts or wires
- Installation is as simple as replacing your factory bulbs
ULTRA BRIGHT: LED - 3x BRIGHTER THAN YOUR STOCK BULBS. One of the brightest LED's available today.
LED TECHNOLOGY: Compared to stock bulbs, LEDs have a quicker refresh rate. When you hit the brakes, LED's instant on are micro seconds quicker than incandescent bulbs and that makes a big difference from vehicles that trail behind. Quick illumination compared to stock bulbs.
OPTIONAL LOAD EQUALIZER: The Turn Signal Resistor Kit is designed to correct the issue of rapid flashing.
TIP: Some bikes may require a plug n play load equalizer/resistor since LED bulbs draw very little power.
CALIFORNIA residents only:
WARNING: This product contains chemicals including DEHP, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information visit https://www.p65warnings.ca.gov
- 1157 HARLEY
- PLUG N PLAY
- PACKAGE CONTENTS:
- OPTIONAL: (1) LED BULB / (2) LED BULB
- POWER DRAW:
- 0.6A power draw. Typical stock bulb draws about 4-5AMPS
I had a one-year old set of Custom Dynamics LED turn signals on my Road Glide, and one unit failed. Upon inspection, there was corrosion on the circuit board, probably caused by Florida Humidity. I have other Pathfinder LEDs on my bike, so I took a good look at their turn signals. The electronics are in a sealed housing, and there are no exposed wires or plugs, so the humidity here shouldn't cause a problem. They are bright and easy to install, I much happier with these.
Price might be a little high though